TiVo Community Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I can't figure out how (if it's even possible) to assign a different code for each Tivo with the universal remote. The remote is a One For All model URC 6131nw. Any help would be much appreciated.
 

· Registered
Joined
·
1 Posts
The only way with your remote is to mail it back in to One For All and they will add the additional codes for the different remote addresses. I did this for the same remote just today. Call One For All at to get a ticket number to set this up.
 

· Remote Czar
Joined
·
4,289 Posts
Exactly, you need to have it upgraded by UEI. only cost to you is shipping there, Ohio. turnaround is a week. If you were to get the OFA urc-6820 or 8820, they have preset codes for tivo addresses 1-4.
 

· Astute User
Joined
·
11,383 Posts
If you are technically inclined, you could add the EEPROM, JP1 connector, and jumper yourself, build a JP1 cable, nd upgrade it yourself.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top