TiVo Community Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,601 Posts
Discussion Starter · #1 ·
My first time using copykern. I got two error messages when using the canned copykern commands built into the PTV large kernel disk. First ":no such file or directory" after the -k /cdrom/s1_kernels/kernel-3.0/vmlinux-3.0.px.gz command ran. Then "writing 1058304 bytes to /mnt/kernel.orig" ran. Then the error message "unknown boot block signature: 0xdb1dfac2" on a new line. Then final line indicates the kernel was updated.

I assume the first error message was no problem since that directory was not already on the hard drive, but is the second one important or not?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top