TiVo Community Forum banner
1 - 1 of 1 Posts

5,715 Posts
Pre-amps are usually split into two pieces.

The amp is located at the antenna.

The power source is located inside.

A very short cable is run from the antenna to the pre-amp. Then a cable is run from the pre-amp inside to the power source. A final cable is run from the power source to the item that needs the antenna input.

The power source will be located with your HD-Tivo. Plug it into the same UPS.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.