TiVo Community Forum banner

TiVo remote going into ir mode momentarily and acting weird.

780 Views 4 Replies 3 Participants Last post by  Mikeguy
I have tried multiple remotes,changed batteries and done global resets also checked for rf interference. No matter what I try all of my remotes seem to get crazy on me. I will be going through the guide or browsing a bit and the remote will stop sending a rf signal the light on it will turn red when I’m pushing buttons for a bit then after a few more pushes it turns yellow again and works. Happens with multiple remotes (7 so far). Just frustrating cause I have my TiVo hidden and don’t have line of sight. I’m just guessing it’s not sending an rf signal when the light is red.



Sent from my iPhone using Tapatalk
1 - 5 of 5 Posts
When remote light is red, its sending IR.
Likewise, when yellow its sending in RF.

When the remote does not do its connect with RF it can momentarily switch to IR (red light) to try to control the Tivo.
There is not much to do except try new batteries, or reset remote, pair the RF again.
IR does not need to be paired and can work with multiple units.
Pretty much tried all of the above plus some.I may just put some sort of it repeater in and just give up on the rf


Sent from my iPhone using Tapatalk
Found the culprit had a small Bluetooth audio transmitter plugged in to a USB port behind the tv. It was causing all the trouble interfering with the rf signal.


Sent from my iPhone using Tapatalk
  • Like
Reactions: 3
Found the culprit had a small Bluetooth audio transmitter plugged in to a USB port behind the tv. It was causing all the trouble interfering with the rf signal.
I had to smile at this. :)
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top