TiVo Community Forum banner
1 - 3 of 3 Posts

·
Jeep Ninja
Joined
·
279 Posts
Discussion Starter · #1 ·
I installed my TivoHD last night and all appeared to go well. Only getting analog stuff now, cable card to be installed next Thursday.

I went through the setup and it appeared to d/l an update and I rebooted. I"m now at the "b" revision - but I still don't see any swivel stuff.

Is there a way to enable it, or is this one of those things that I just have to wait longer than 24 hours for it to figure out what's going on?

I tried searching and it appears that some folks have also seen this issue, but other than a rant about a bad Tech Support person @ TiVo, I didn't see any solution.

Is this supposed to work w/o cable cards?

Thanks,
Chad
 

·
Registered
Joined
·
6,631 Posts
I had the same issue but Swivel Search was functional about 36 hours after I plugged in the TivoHD.

Try Swivel Search again tonight or tomorrow. I get the impression that the box has to download additional data and/or index existing data before that feature will function.
 

·
Jeep Ninja
Joined
·
279 Posts
Discussion Starter · #3 ·
Thank you! Patience is not one of my strong suits....I've already called several VZ stores to see if I can pick up a set of cable cards or a single M-card before my install on Thursday....no such luck. grrrr....
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top