TiVo Community Forum banner
1 - 2 of 2 Posts

· Registered
72 Posts
Discussion Starter · #1 ·
My HR10-250 was becoming increasingly unresponsive so I selected the option to clear out all guide data and todo information. It's been stuck on that for over a week. After waiting a week, I pulled the plug and rebooted, after the "Almost there a few more seconds" screen, it goes back to the "clearing guide data and todo list" screen. Is there a way to force the HR10-250 into GSOD mode on bootup so that it will run the disk diagnostics? I've searched all over the forum and found some instructions that don't seem to work with the HR10-250. Also, is there a way to force the HR10-250 to boot from the other partition?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.