TiVo Community Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Is there any way to utilize a single RG6 cable to carry two outputs of a multi-switch?

I have a length of RG6 in a wall, and on one end I have two outputs from the 3-LNB dish's multiswitch and at the other end I need two inputs for the TiVo's tuners. I'd liek to avoid pulling another cable, and am not sure how best to do that if I have to.

Thanks in advance...
 

· Registered
Joined
·
8 Posts
Discussion Starter · #9 ·
Gary, that was a great help.

One more question...

Since I have a single length of RG6 already in the wall, should I use it to pull a string? It seems all the talk about the sticks assumes I am starting from scratch.

And by the way, I have a concrete slab (no crawlspace) and this is on the first floor with no access to the space between the floors. In other words, I'm flying relatively blind.

Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top