TiVo Community Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I see that I have audio inputs on the back of my series 2 TiVo, but how do I get TiVo to record from that source? I can't find anything but the regular cable channels to record. I'm using this to record meeting minutes.

Thanks,

Paul
 

·
Dumb Blond
Joined
·
38,716 Posts
You also have video inputs. When you run Guided Setup, you tell the TiVo which input to use for your programming source. If you selected "cable without a box", then it is the RF input that is used and the audio/video inputs are ignored.

You could rerun setup and say that you also have satellite and then the TiVo would use the A/V inputs when a channel above 99 was selected. Note, though, that a video signal is required for TiVo to record. You can't record audio-only.

Wouldn't a tape recorder work as well?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top