TiVo Community Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
1. If my cd drive is a secondary master, should the jumper on it be set to slave or master?

2. If i'm installing an image from a cd (bak file is on cd) then would i have to take out the mfstools cd? or would i need to cd drives?


3. I have a maxtor diamonmax 9 plus. How would I set that jumper to slave? I dont understand the labeling on it..i think it's asking me to put the jumper horizontally on the top 2nd and top 3rd pin. Is that correct? I thought i had to remove the jumper entirely to make it a slave?

Thanks!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top