TiVo Community Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have the pace DVB freeview adaptor. Picked it up off ebay because I knew my dad had one and it had been working with tivo flawlessly for years.

But it has an occasional problem where instead of it performing a channel change it just brings up the channel banner (as if the info button had been pressed on the pace remote). This is happening about every 3 or 4 days.

Once the info banner is being displayed the pace does not accept any further channel changes. Therefore Tivo misses all its recordings until the banner is cleared by pressing the info button.

Anyone experienced this... any ideas?

Thanks,
Ian.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top