TiVo Community Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a new series 3 with two cable cards from Insight that I am having audio problems with. When I first boot my Tivo and it goes through the THX, my receiver plays audio in Dolby Digital mode. However once I go to live or recorded programming it switches back to PL II. I can't think that I have something hooked up incorrectly with it playing Dolby D on boot. So my question is, anyone else having a similar problem with Insight Cable?
 

·
Registered
Joined
·
421 Posts
The channel you are tuning to has to be transmitting in Dolby Digital for your receiver to recognize it.

You should also check your S3 DD settings by going to Messages and Settings --> Settings --> Audio --> Dolby Digital. Make sure "Dolby Digital" is selected instead of "DD to PCM".
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top