I have a Hughes HDVR2 that started getting stuck at "Powering Up" after an AC Power flicker. This was ~ 9 months ago. Since I had an HR10 on the primary viewing TV and the set the HDVR2 was on was used mainly for news in the morning I just hooked up an old standard received and put the HDVR2 in the storage room.
Last week I found out a buddy of mine had just purchased a copy of Spinrite so we ran the HDVR2s disk thru a level 4 scan.
Today I put the disk back in the HDVR2 and when I plug it up I get nothing. No power light. No fan. Nadda.
I didn't see an obvious fuse or circuit breaker. I checked all the connectors.
My voltmeter is busted but I did check and there is AC getting to the power supply.
It has been disconnected from AC for ~ 9 months. I did NOT try it before I removed the disk.
Any ideas?
Last week I found out a buddy of mine had just purchased a copy of Spinrite so we ran the HDVR2s disk thru a level 4 scan.
Today I put the disk back in the HDVR2 and when I plug it up I get nothing. No power light. No fan. Nadda.
I didn't see an obvious fuse or circuit breaker. I checked all the connectors.
My voltmeter is busted but I did check and there is AC getting to the power supply.
It has been disconnected from AC for ~ 9 months. I did NOT try it before I removed the disk.
Any ideas?