TiVo Community Forum banner
1 - 4 of 4 Posts

·
Member
Joined
·
51 Posts
Discussion Starter · #1 ·
I am researching and hopefully moving from a couple of tivo's to an HDTV set up and a nice plasma. I have my lines going to a terk multiswitch with 5 lines out, 2 tivo's and a single to another tv. To grab the local HDTV broadcasts with an antenna in the roof, can the coax for the antenna be ran into the UHF in on the terk and than spliced out from a tivo line at the tv? Or do I need to run another line <sigh> through the walls just for the OTA antenna? Thanks!
 

·
Registered
Joined
·
1,195 Posts
You probably have a 5 input, 8 output, Terk multiswitch. The 5th input is for an OTA antenna. The OTA will appear on every output line. However, you have to put a dilpexer on each line that you want to see OTA.

You put the diplexer, which splits the satellite and OTA signals, on 1 line at each location that you want OTA. The diplexer ihas 2 outputs (marked) 1 for Sat and 1 for antenna (OTA).
 

·
Registered
Joined
·
16 Posts
assuming you have the Terk 55 antenna (omnidirectional, powered) there is an important note on the Diplexers you must use on the box side:

Must be a DC passing only on the satellite side.

Diplexers come 3 ways:
no power passing
passing on both sides
passing on sat side only.

That is what you want
 
1 - 4 of 4 Posts
Top