[Sonny]

I had two 250G HDDs and after 2 years, I can't change channels anymore or picture stutters so I went and set for "Clear and Delete Everything". It has been 2 days and it has not finished. Pull the power plug a couple times, but goes back to the same clearing mode with the red LED blinking.
What to do?

 

[ebonovic]

Doo Doo Duuuuuuuuueeeee Doo Doo Duuuuuuuuuuuuuuuue

One of your two drives must have taken a dive.

I would pull them, and figure out which it is using the diagnostics.
The obtain a new image (via PTVUpgrade or other places) and reinstall on the good drive and get the bad one replaced.

 

[kimsan]

Doo Doo Duuuuuuuuueeeee Doo Doo Duuuuuuuuuuuuuuuue

One of your two drives must have taken a dive.

I would pull them, and figure out which it is using the diagnostics.
The obtain a new image (via PTVUpgrade or other places) and reinstall on the good drive and get the bad one replaced.

Earl has it nailed. *Once* I did a Clear and Delete on my 250x2 HR10. It took overnight, but not 2 days.

Time to hit up Newegg (or your favorite source) for a replacement.

Did you at least make a backup of SPs and Thumbs before you upgraded? It's a lifesaver if you did.

Sorry for your loss.

 

[dfioc]

One of your two drives must have taken a dive.

Yup. Mine did the same but I waited for 4 days until getting mine replaced. You've got a bad drive.

 

[Sonny]

Replaced the HDD's and everything is up and running. Thanks everyone.