TiVo Community Forum banner
1 - 1 of 1 Posts

· Registered
14 Posts
Discussion Starter · #1 ·
My remote wasn't able to control my S2 today for some reason.

I had to to reset the code to 0 to get the remote working again. Upon getting it working, I could see that the tivo it had just gotten the 9.1 service update. I was able to set the code back to 2 as it was originally.

Now updating the S3, so we'll see if this messes up the remote code too.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.