Joined
·
134 Posts
Remote key presses are ignored at various times in different locations of the system. It can be quite irritating, especially when it happens during a trick play sequence. Here is one repeatable sequence that I have pinned down:
Start on any tuner
Left arrow
Choose a favorite channel and select it
Allow the info bar to disappear
Push any other key on the remote
The edge will not perform the desired action
You will see that the Edge receives the signal because the yellow light blinks when you press the key. But the unit does not respond to the command.
I use a URC remote, so I took out the original Edge remote and tried it. Same result.
I have a 2nd Edge, so I tried that one. Same result.
The only thing I might be doing different than most of you is using code sets 1 and 2 instead of zero so I can control each unit separately. I don't recall if the problem existed when I used the zero code set.
I can't be alone with this issue...
Start on any tuner
Left arrow
Choose a favorite channel and select it
Allow the info bar to disappear
Push any other key on the remote
The edge will not perform the desired action
You will see that the Edge receives the signal because the yellow light blinks when you press the key. But the unit does not respond to the command.
I use a URC remote, so I took out the original Edge remote and tried it. Same result.
I have a 2nd Edge, so I tried that one. Same result.
The only thing I might be doing different than most of you is using code sets 1 and 2 instead of zero so I can control each unit separately. I don't recall if the problem existed when I used the zero code set.
I can't be alone with this issue...
