TiVo Community Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
New poster to this forum and I hope I'm in the right forum, so here goes…

I have the 3LNB dish and currently have 4 receivers hooked to it. I just purchased an new DVR to replace one of the standard receivers and would like to hook up both inputs to the unit. I know I can get a 4x8 or 5x8 multiswitch to accomplish this but I don’t really want to have to run another cable to receivers’ location. Is it possible instead to take the one lead that is attached to the receiver and using a 1x2 multiswitch (not a splitter) to create two inputs from the one cable run?

Thanks in advance.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top