TiVo Community Forum banner
1 - 3 of 3 Posts

·
der Neuerer
Joined
·
3,419 Posts
Discussion Starter · #1 ·
This thread is to discuss the problem of why certain HDDs do not work with the Bolt. So far with my limited data points, my current hypothesis is that drives that do not support the streaming command set are the problems. As more data points are collected, we can evaluate this hypothesis further.
 
  • Like
Reactions: rtoledo

·
der Neuerer
Joined
·
3,419 Posts
Discussion Starter · #2 ·
So I found a few more drives to test. These did not have the streaming set supported but yet they booted. So that does not seem to be the issue. One other thing that pops out is that HPA and DCO is not supported on the non-booting drive. However, when I examine the drives that do boot, there is no HPA or DCO changes to the drive. I would doubt that as a cause for non-booting. Need more data points.
 

·
der Neuerer
Joined
·
3,419 Posts
Discussion Starter · #4 ·
Don't know. Will need to check.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top