TiVo Community Forum banner
1 - 12 of 12 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi

I have a DirecTV phase lll dish, which has 101, 110 1nd 119, triple LNB. Has 5x4 switch - According to some of the research I ahve done, all four out put are identical.

I need 61.5W satillite, Can anybody help me please?

Thank you
 

· Just hangin'
Joined
·
12,613 Posts
You'll need a second dish (round with dual output LNB) to receive the 61.5 sat. And a 6x8 multiswitch to integrate that sat with the others. Go here http://emantechnology.com/lookangle.asp and enter your zipcode and select the 61.5 sat from the list. This will give you the alignment parameters for that dish. Connect the four outputs from the PH 111 to the 6x8 switch and the outputs from the 61.5 to the flexport inouts on the switch.

Refresh my memory, what DirecTV channels are on 61.5?
 

· Registered
Joined
·
4 Posts
Discussion Starter · #9 ·
Thank you guys!

Sorry guys, I did not explain what I need. I can setup only one dish, as i am allowed to set up more then one, due to condo rules. I have phase lll 18x20 with triple LNB (101, 110 and 119), each output is identical.

So, the BIG question is what should I do, I need to get 61.5W
1) get a new dish
2) get a new LNB
3) use some kind of switch

Please help.
 

· Just hangin'
Joined
·
12,613 Posts
To the best of my knowledge, there is no one dish solution to also get the 61.5 satellite. And if there were, it would probably be quite large. :) Larger than what the condio rules might allow.

Exactly why do you need the 61.5 dish?
 

· Registered
Joined
·
4 Posts
Discussion Starter · #11 ·
Thank you for your reply Jim

I need the 61.5 for the B4U music and other forgien channels.

Please tell me if I can use just one dish for 61.5W only, or do I have to use 2 dishes to get 61.5W.
If one dish is good enough then would I need to buy a specific dish or can I modify the exsiting one.
Thanks!
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top