TiVo Community Forum banner
  • TiVoCommunity.com Ambassador Program Now Open! >>> Click Here

direct tv d11

1K views 3 replies 3 participants last post by  Edmund 
#1 ·
i have a customer that was just upgraded to a d11 reciever from directv and i am getting some unpredictable results when trying to change channels. I see there has been some issues with the d10 so i'm going to assume this to be the case with the d11. does anyone know of a code for the ir for the d11 yet?

thanks dwschumann
 
#3 ·
i talked to tivo customer service and they told me to try ir code 10074. if that doesn't work u can check and make sure the ir blaster is working but u will need a digital camera. point the camera at the blaster and change the channel on the tivo , u should see a flash on the screen of the camera when the channel is changed. other than that they couldn't help me much....
 
#4 ·
On the d11 oem remote, what is the preset code you're using, 00001 or 00002? You can blink back the code on the remote:

1. DTV
2. press and hold MUTE & SELECT for two blinks
3. enter 9-9-0
4. tap #1 key, count blinks, if there are none, the digit is zero.
5. tap #2 key, count
6. tap #3 key, count
7. tap #4 key, count
8. tap #5 key, count

If its using anything other then 00001, that's why the tivo code isn't working.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top