TiVo Community Forum banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
I have Verizon FiOS TV with a Motorola Set-top Box (STB), and Tivo Series 2. Tivo serial port control of the Moto STB works perfectly. However, occasionally due to a power glitch or some unknown gremlin, the STB turns itself off (actually in stand-by mode awaiting an IR "on" command) and then ignores all serial commands from Tivo and all Tivo recordings are just a black screen until I manually turn the STB power ON.

I have two questions:

1. Can the Tivo send a "power on" command to the STB just prior to any channel change? If yes, how can this be done?

2. If the STB is in this stand-by mode, will it recognize and act on a power on command from the Tivo?

If the answers to #1 and #2 are both yes, then I have a solution to my occasional problem.

Thx, Ken
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.