TiVo Community Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi guys i need some help i bought a use philips HDR112, i am trying to upgrade by adding a network card and a new hard drive. I follow the Steve Jenkins how to guide. in step 2.8.3 i creat the mount points. and then in step 2.8.4 i try to mount the partitions it say it was mounted successfully and then it also say you must specify the filesystem type. When i run the df comand to see the devices on the mount points.all i see is

file system 1k-blocks used Available use % mounted on
/dev/ram0 15863 9795 6068 62%/


there was no 4, 7 or 9 partitions.

my question is do i have to subscribe to tivo to get back these partitions on the drive or is there anything else i can do to get these partition back?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top