TiVo Community Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
I am seeing similar problems on my DirecTiVo (Hughes) also in the SF Bay Area, and as far as I can tell it is a failing input. Play with your Sat Signal Strength testing under Settings -> Satellite -> Test Satellite Signal Strength. On mine, I see a few of the transponders on satellite 119 that will switch between 0 and the mid to high 80s on input 2. (transponders 26, 27 at the moment). If I swap cables the problem stays on input 2.

I chatted with the folks at WeakKnees a bit, they think it's probably an input going bad.

I figure this is my excuse to get a Series 3 and finally get HDTV (unfortunately with Comcast).
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top