TiVo Community Forum banner
1 - 3 of 3 Posts

·
CUBS WIN !
Joined
·
43 Posts
Discussion Starter · #1 ·
I need to try installing a variable attenuator for my OTA signal.
I want to install it behind my HR10-250, so I can monitor the adjustments.
Will that be OK? or must it be located near the antenna end of the cable?
Same with a FM trap?
Thanks
 

·
Registered
Joined
·
29 Posts
In regards to the FM Trap I have always been told to install it as close to the device as possible to negate any possible interference that the incoming line might pickup. I do not see why the attenuator placement would be affected as all it does is induce or reduce resistance depending on the need.
Scott
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top