TiVo Community Forum banner
1 - 3 of 3 Posts

·
Just a boring dude
Joined
·
32,098 Posts
essentially, you can follow the procedure at my original unguide since 7.xx and 6.2 use the same linux kernel.
Just when looking at the author file, leave out the "route" commands since a standalone MUST contact Tivo for guide data and what not. Also remove the reference to fakecall.tcl from the author file.
http://www.thewallens.net/tivo/tivo_unguide.html

This will work ONLY on the TCD24XX series 2's. the 5400 series require soldering and replacing a chip in order to gain access to BASH.
 

·
Just a boring dude
Joined
·
32,098 Posts
well it can definitly turn your unit into a doorstop if you aren't careful but the instructions are pretty well laid out.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top