unknown boot block signature: xxxxxxxxx

Discussion in 'TiVo Upgrade Center' started by funtoupgrade, Jan 5, 2006.

  1. funtoupgrade

    funtoupgrade New Member

    2,000
    0
    Mar 15, 2005
    My first time using copykern. I got two error messages when using the canned copykern commands built into the PTV large kernel disk. First ":no such file or directory" after the -k /cdrom/s1_kernels/kernel-3.0/vmlinux-3.0.px.gz command ran. Then "writing 1058304 bytes to /mnt/kernel.orig" ran. Then the error message "unknown boot block signature: 0xdb1dfac2" on a new line. Then final line indicates the kernel was updated.

    I assume the first error message was no problem since that directory was not already on the hard drive, but is the second one important or not?
     

Share This Page