Advertisements Hi all, Hoping someone can lead me down the right path. I have a lifetime Series 2 540040 with a dead hard drive. I have restored the image provided by this forum to a working 80 GB hard drive using WinMFS. The drive will boot right into guided setup and gives me no information for any zip code. After trying a few zip codes and rebooting the drive goes to Installing a Service Update. This will take a few minutes. After this the box gets stuck in a reboot loop for Welcome Powering Up. I have repeated this procedure twice with the same result each time. The image restores with 9.3.2b and I assume after trying to get the zip code information it gets the 9.3.2c update but the install fails for some reason and gets stuck in the loop. I would love to hear any thoughts about this strange issue.