S3 remote setting for 2 Tivos

Discussion in 'TiVo Series3 HDTV DVRs' started by marshallld, Jan 1, 2007.

  1. marshallld

    marshallld New Member

    13
    0
    Sep 2, 2002

    Advertisements

    I've gone through the set up procedure over 6 times to enable the S3 remote to use the #1 DVR switch for my S3 and #2 for my Humax DVDR-Tivo. Every time it switches both Tivo's to the last inputted remote code. This was easy when I did it with my DVDR and S2 and it went very easily a couple years ago.

    Yes I've covered the sensor on the other Tivo - gone to extent of overing the entire face with 2 thick magazines.

    Help. Without this set up having both Tivos in the same room is useless.
     
  2. Shawn95GT

    Shawn95GT Tivo, in HD!

    887
    0
    Oct 7, 2005
    Phoenix, AZ
    Program the remote first.

    Only get one Tivo in the system info screen at a time ;). Once in, confirm the intended one switches from zero to one and get out of the system info screen.

    Then do the same for the other setting it to two.

    Done deal.
     
  3. Edmund

    Edmund Remote Czar TCF Club

    6,696
    319
    Nov 8, 2002
    Boone. IA
    Did you program the dvr1/dvr2 switch? dvr1/dvr2 doesn't mean Address #1/ Address #2, it comes set zero on both sides of the switch.
     
  4. bobharp

    bobharp Member

    49
    0
    Jan 17, 2003
    I've been there.

    Check out:
    http://www.tivocommunity.com/tivo-vb/showthread.php?p=4721868&&#post4721868

    Good luck,
     

Share This Page

spam firewall

Advertisements