Remote mishaps

Discussion in 'TiVo Help Center' started by MBlaustein, Dec 20, 2002.

  1. jazacher

    jazacher New Member

    7
    0
    Mar 25, 2009
    Parker Co

    Advertisements

    Edmund~ I should've said that I have replaced the 16 remote with the radioshack 15-134.. still power button is not working.. any thoughts on the dvr not recognizing the service?
     
  2. Edmund

    Edmund Remote Czar TCF Club

    6,510
    242
    Nov 8, 2002
    Des Moines. IA
    to get the power key in the DVR device on the 15-134 to control the standby command, try the following:

    1. dvr
    2. press and hold P for two blinks
    3. enter 9 9 4
    4. tap P for one blink
    5. enter code 0 0 1 5 2
    6. press POWER key

    Call Directv and have them hit the receiver again, there certainly isn't anything on your end to do.
     
  3. jazacher

    jazacher New Member

    7
    0
    Mar 25, 2009
    Parker Co
    edmund~ the channel keeps changing to 152... what step am I missing?
     
  4. Edmund

    Edmund Remote Czar TCF Club

    6,510
    242
    Nov 8, 2002
    Des Moines. IA
    Alright you will have to choose a different key other then the power key which looks like it will not allow Advanced codes mapped to it.

    Perhaps the black VIEW TV key in the device section of the remote, or any other but the power key. Make sure you follow the steps above to the letter, the blink of the key as you first press it does not count towards the two blinks, wait as you're pressing the P for it to blink two more times. In step 4, the initial blink as you press it, is all it needs.
     
  5. sg000

    sg000 New Member

    10
    0
    Feb 6, 2006

    Advertisements

    Not sure the following info was covered in the prior posts, it took me some time to figure out, so I'll share here.

    I have 3 remotes that ran 1 TIVO and then brought a 2nd tivo online with a 4th remote. I had to do the remote channel change on BOTH tivo's (with a different remote on each) to separate channels. And then I had to do the remote channel change on the other 2 spare remotes to match the tivo I wanted it to run.

    For example, Tivo 1 is set to channel 2 and 3 of the remotes are set to channel 2, and Tivo 2 is set to channel 5 and 1 remote set to channel 5.

    When TIVO's and Remotes are out of the box, they seem to be "universal" (listed as "Not Set" in the settings). Remotes will control all units, and all "not set" units will receive from any channeled remote.
     
  6. Edmund

    Edmund Remote Czar TCF Club

    6,510
    242
    Nov 8, 2002
    Des Moines. IA
    bump
     

Share This Page

spam firewall

Advertisements