problem with upgrade

Discussion in 'DirecTV TiVo Powered PVRs & Receivers' started by Automan320, Sep 25, 2007.

  1. Automan320

    Automan320 New Member

    7
    0
    Sep 4, 2002
    I was upgrading a hr10-250 to two 250g max quickview. Everything was going great. After I was finished and mounting b drive to bracket it slipped out of my hand and dropped on tile floor and damaged the drive. My question is this? Is it possible to rebless a drive the same size or bigger with out recopying the a drive or do i need to start from scratch. I had saved the recordings so there is a lot of waiting time involved. I did save the original drive.

    Ted
     
  2. Automan320

    Automan320 New Member

    7
    0
    Sep 4, 2002
    :) No one had responded to my message. So I went ahead and remarried a new drive and this does work. Now remeber this was just a defective drive never been up and running. All of the recording are still there on the Primary drive. I did the command

    mfsadd -r 4 -x /dev/hdx /dev/hdx where the x 's are the drive letters

    Thanks Ted
     
  3. Billy66

    Billy66 Again with shoelaces

    3,273
    0
    Dec 15, 2003
    Good work Ted, glad it worked out for you.
     

Share This Page