After fretting for a couple of weeks trying to restore a saved original series3 image to a 1.5TB drive I was forced to spend a lot of time searching this forum for help. I learned that if one needs to use MFSlive for any reason, then one can make the restore a simple two minute process. The solution is to use a 1TB target drive or smaller. If one goes larger there are a number of obstacles that need to be overcome which were not worth my time. If one reads all the instructions in the complete MFSlive guide you are led to believe that restoring to a 1TB (or larger drive) without using a hacked kernal will not work. To the contrary, it works fine as long as the drive is 1TB or smaller. Hopefully this post will help anybody who has had the same problem.