"No Signal" when using Pandora

Discussion in 'TiVo Premiere DVRs' started by comgenius1, Oct 19, 2011.

  1. comgenius1

    comgenius1 New Member

    90
    0
    Feb 15, 2004
    Whenever I pull up Pandora on my Premiere XL, my tivo goes black and then I get a "No Signal" banner on the tv. If I turn the TV off and back on, It comes up to the pandora screen and works just fine. If I go back to live tv, it switches flawlessly, but if I go to pull Pandora back up, I have to turn the tv off and then back on. Its a 40" Toshiba connected with an HDMI cable. I've also had the same issue with YouTube as well. Any ideas?
     
  2. rainwater

    rainwater Active Member

    7,066
    5
    Sep 21, 2004
    What output modes do you have your TiVo set to? And what is the model of your tv?
     
  3. comgenius1

    comgenius1 New Member

    90
    0
    Feb 15, 2004
    1080i and 1080p. The tv is a toshiba 40RV525U and is a 1080p tv.
     
  4. mrrickva

    mrrickva New Member

    1
    0
    Jul 9, 2008
    I'm a little late to the discussion, but... I was going crazy with my Toshiba 40RV525U (hooked up to my Premier) going black when trying to get to Tivo Central. I stumbled onto this thread and the light bulb lit up. I set the Tivo video output to 1080i only and the problem was solved. Thanks
     
  5. aaronwt

    aaronwt UHD Addict

    23,120
    1,093
    Jan 31, 2002
    Northern...
    But the TiVo can only pass through 1080P. It cannot scale to 1080P. The Pandora app will be in 1080i if 1080P and 1080i are selected.(it will be in 720P if 720P, 1080i, and 1080P are selected). So there must be some kind of issue going on since the 1080P set should have no issue with 1080i.
     

Share This Page