/ Register

No Audio over HDMI with new Sharp LCD

Discussion in 'DirecTV TiVo Powered PVRs & Receivers' started by Joe Jensen, Sep 16, 2007.

  1. Sep 16, 2007 #1 of 6
    Joe Jensen

    Joe Jensen New Member

    99
    0
    Jul 7, 2003
    Arizona
    I have the latest Sharp LCD, a LC-42D64. So far I like it a lot. However, I can't seem to get Audio over HDMI. The Sharp is supposed to have HDMI1.3, so I'd think it's pretty compatible. Is the HR10-250 really incompatible with a lot?
     
  2. Sep 16, 2007 #2 of 6
    TyroneShoes

    TyroneShoes HD evangelist

    3,604
    0
    Sep 6, 2004
    No. It is 1.1, and 1.3 would be backward compatible, so I think it's not a compatibility issue. About the only problems like that were when the HR10 presented 1.1 to TVs or AVRs that were at 1.0.

    Check your DD/5.1 settings on the HR10.
     
  3. Sep 17, 2007 #3 of 6
    tvl76

    tvl76 CUBS WIN !

    44
    0
    Oct 5, 2005
    Peoria, AZ
    you have to setup your HR10 for Dolby to PCM
     
  4. Oct 5, 2008 #4 of 6
    Rich Peterson

    Rich Peterson AVS Press

    76
    0
    Jan 7, 2000
    St Paul, MN
    Help! I, too, can't get any audio over HDMI out of my HR10-250. I have it set to output Dolby to PCM and still nothing. I have tried it with both a Samsung and Sony HDTV and nothing on both. Is this a known problem?
     
  5. Oct 5, 2008 #5 of 6
    Bondelev

    Bondelev Member

    330
    0
    Nov 27, 2005
    Burbank, CA
    Are you going to the monitor directly from the Tivo, or through an amp first?

    I know on my Onkyo, it does not pass through HDMI audio for some reason. I have to use the digital optical cable.
     
  6. Oct 5, 2008 #6 of 6
    Rich Peterson

    Rich Peterson AVS Press

    76
    0
    Jan 7, 2000
    St Paul, MN
    I hooked the HDMI cable directly from the HR10-250 to the HDTV and still no sound. I had previously used the optical out to a receiver and that was working OK, but now I put my HR10-250 in another room and want to just have both audio and video go directly to the TV over HDMI.

    It's almost as if my HR10-250 thinks it's supposed to output the audio through the optical out only as it did before, but I can't see any setting where that would be indicated.
     

Share This Page