Need image file for TiVo Series 3 HD

Discussion in 'TiVo Series3 HDTV DVRs' started by nyjack, Aug 6, 2016.

  1. ThAbtO

    ThAbtO TiVoholic by the bay TCF Club

    11,521
    877
    Apr 6, 2000
    SF Bay Area
    Sent.
     
  2. dreamland95

    dreamland95 New Member

    2
    0
    Nov 22, 2009
    Thank you.
     
  3. May 4, 2020 #223 of 234
    davissc83

    davissc83 New Member

    2
    0
    Feb 25, 2008
    I have a series 3 with lifetime i am trying to get running again. can I get an image of a 652 and the software? Thanks
     
  4. May 4, 2020 #224 of 234
    ThAbtO

    ThAbtO TiVoholic by the bay TCF Club

    11,521
    877
    Apr 6, 2000
    SF Bay Area
    Sent.
     
  5. May 6, 2020 #225 of 234
    davissc83

    davissc83 New Member

    2
    0
    Feb 25, 2008
    Thanks so much
     
  6. plocatelli

    plocatelli New Member

    5
    0
    Nov 17, 2009
    Santa Clara, CA
    Would you mind PMing me as well. Same issue.
     
  7. ThAbtO

    ThAbtO TiVoholic by the bay TCF Club

    11,521
    877
    Apr 6, 2000
    SF Bay Area
    You need to specify the model.
     
  8. plocatelli

    plocatelli New Member

    5
    0
    Nov 17, 2009
    Santa Clara, CA
    Yes, my mistake. It's for the 658. And I am a total noob at this, so any instructions would be most appreciated. Thanks a bunch for the prompt response.
     
  9. ThAbtO

    ThAbtO TiVoholic by the bay TCF Club

    11,521
    877
    Apr 6, 2000
    SF Bay Area
    Sent.
     
  10. thekid5

    thekid5 New Member

    1
    0
    Nov 10, 2009
    Could I also get an image for TCD652160.
     
  11. ThAbtO

    ThAbtO TiVoholic by the bay TCF Club

    11,521
    877
    Apr 6, 2000
    SF Bay Area
    Sent.
     
  12. Bernie_Herbst

    Bernie_Herbst New Member

    2
    0
    May 20, 2020
    State...
    Do you have an image of TCD648250B? Thank you in advance.
     
  13. ThAbtO

    ThAbtO TiVoholic by the bay TCF Club

    11,521
    877
    Apr 6, 2000
    SF Bay Area
    Sent.
     
  14. Bernie_Herbst

    Bernie_Herbst New Member

    2
    0
    May 20, 2020
    State...
    Thank you very much, it worked perfectly. Instructions were good. Just a comment about steps five and six. It appears that step six Tool/Super size is an off/on switch that should be turned on before MSFadd. When I went to turn it on I got an error message. In conclusion, when the MFSadd was completed, I did have the full 2TB accessible when installed in the Series 3. Maybe it is an unnecessary step? I have another drive coming from EBay, just in case this one had failed. When I get it I'll try the step swap and report back my results. Thanks again ThAbt0.
     

Share This Page