Mixing MoCA devices on a split cable run

Discussion in 'TiVo Help Center' started by Ratamacue, Aug 9, 2020.

  1. Ratamacue

    Ratamacue New Member

    26
    2
    Dec 12, 2002
    Southeastern PA

    Advertisements

    I have a basic question on mixing MoCA devices on a cable run that includes a splitter. My coax to two different upstairs rooms goes through an accessible splitter. After the splitter is a Tivo mini which is a MoCA 1.1 device. My intention is to purchase a pair of Gocoax WF-803M MoCA 2.5 units and place one on the other end of the split and the other as host near my router. Will the MoCA 2.5 devices communicate at 2.5 speeds with a 1.1 device present on the other end of the split coax run?

    TIA for the assistance...
     
    Last edited: Aug 9, 2020
  2. UCLABB

    UCLABB Well-Known Member

    5,244
    1,402
    May 29, 2012
    Riverside, CA
    I’m pretty sure that it would not affect other devices unless it was communicating with in which case it would be at the lower speed.
     
  3. Ratamacue

    Ratamacue New Member

    26
    2
    Dec 12, 2002
    Southeastern PA
    Thanks. I remember reading about certain devices needing to be on a single coax line to get maximum throughput, perhaps Moca 2.0 in turbo mode?
     

Share This Page

spam firewall

Advertisements