MFS Live Copy Issue

Discussion in 'TiVo Help Center' started by finnwake, Aug 5, 2011.

  1. finnwake

    finnwake New Member

    2
    0
    Aug 2, 2011
    I have an HDVR2 and the HD is failing. I tried to use MFS live to copy the drive to another HD. According to the MFS program the copy went fine. The 2nd drive was tested before and is good. When I put the new drive in the unit it gets stuck on the "Welcome Powerin Up" screen. Am I doing something wrong?
    Any help would be appreciated.
     
  2. worachj

    worachj Well-Known Member

    1,472
    115
    Oct 13, 2006
    Eagan, MN
    I had the same issue with my Upgrade due to a Western Digital green drive. Those Green drives have an boot issue due to the Intellipark feature on those drives. If you're using a Western Digital Green drive you may need to run WDIELE3 /d to disable the Intellipark feature. I had to for my upgrade.

    See section 29 in the link for instructions:
    http://www.tivocommunity.com/tivo-vb/showthread.php?p=5616160#post5616160
     
  3. lpwcomp

    lpwcomp Well-Known Member

    9,461
    298
    May 6, 2002
    John's...
    From the OP's description, I assumed that the problem occurred when he powered it up after installing the new drive, so Intellipark wasn't the cause.

    finnwake, post a complete description of what you did, including full information on both drives and all of the steps you took.

    I have to say though that this thread probably belongs in the TiVo Upgrade Center forum.
     
  4. unitron

    unitron Well-Known Member

    16,576
    41
    Apr 28, 2006
    semi-coastal NC
    Did you use backup | restore?

    Or did you use dd_rescue?
     

Share This Page