Insight + Dolby Digital + Series 3

Discussion in 'TiVo Help Center' started by Spaghetti, Aug 12, 2007.

  1. Spaghetti

    Spaghetti New Member

    1
    0
    Aug 2, 2007

    Advertisements

    I have a new series 3 with two cable cards from Insight that I am having audio problems with. When I first boot my Tivo and it goes through the THX, my receiver plays audio in Dolby Digital mode. However once I go to live or recorded programming it switches back to PL II. I can't think that I have something hooked up incorrectly with it playing Dolby D on boot. So my question is, anyone else having a similar problem with Insight Cable?
     
  2. litkaj

    litkaj Member

    257
    0
    Jun 5, 2007
    Exton, PA
    I don't know about your provider, but most of my channels w/ FIOS TV are PCM, not Dolby Digital. The only ones that come over with DD sound are the HD channels.
     
  3. aus1ander

    aus1ander New Member

    516
    0
    Sep 17, 2004
    The channel you are tuning to has to be transmitting in Dolby Digital for your receiver to recognize it.

    You should also check your S3 DD settings by going to Messages and Settings --> Settings --> Audio --> Dolby Digital. Make sure "Dolby Digital" is selected instead of "DD to PCM".
     

Share This Page

spam firewall

Advertisements