Just a quick question. I am currently using a harmony 890 to control my equipment through a wall in a small utility closet. I noticed that occasionally the Tivo will act as if the directional button has been pressed twice. Or the ff/rew button has been pressed twice. This is very frustrating. If you are familiar with the 890 it uses an ir/rf adapter. This adapter sits in the enclosure with your equipment and acts as a bridge between the the rf remote and your equipment that accepts ir signals. I have one of the control wires affixed to the front of the tivo to ensure it receives all of the commands that are sent. I have hidden the other ir emmiter, in case that was where the double signal was coming from, but this didn't help. Any help would be greatly appreciated. Thanks.