direct tv d11

Discussion in 'TiVo Help Center' started by dwschumann, Jan 16, 2006.

  1. dwschumann

    dwschumann New Member

    2
    0
    Jan 16, 2006
    i have a customer that was just upgraded to a d11 reciever from directv and i am getting some unpredictable results when trying to change channels. I see there has been some issues with the d10 so i'm going to assume this to be the case with the d11. does anyone know of a code for the ir for the d11 yet?

    thanks dwschumann
     
  2. jager19

    jager19 New Member

    2
    0
    Feb 20, 2005
    I'm having the same problem...have you found out any more info?

    thanks!
     
  3. dwschumann

    dwschumann New Member

    2
    0
    Jan 16, 2006
    i talked to tivo customer service and they told me to try ir code 10074. if that doesn't work u can check and make sure the ir blaster is working but u will need a digital camera. point the camera at the blaster and change the channel on the tivo , u should see a flash on the screen of the camera when the channel is changed. other than that they couldn't help me much....
     
  4. Edmund

    Edmund Remote Czar TCF Club

    6,260
    189
    Nov 8, 2002
    Des Moines. IA
    On the d11 oem remote, what is the preset code you're using, 00001 or 00002? You can blink back the code on the remote:

    1. DTV
    2. press and hold MUTE & SELECT for two blinks
    3. enter 9-9-0
    4. tap #1 key, count blinks, if there are none, the digit is zero.
    5. tap #2 key, count
    6. tap #3 key, count
    7. tap #4 key, count
    8. tap #5 key, count

    If its using anything other then 00001, that's why the tivo code isn't working.
     

Share This Page