1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Aftermarket or DIY Bolt case?

Discussion in 'TiVo Coffee House - TiVo Discussion' started by kkoh, Oct 11, 2018 at 9:43 AM.

  1. kkoh

    kkoh Member

    38
    14
    Mar 31, 2017
    oHIo
    Anyone seen/heard of such a non bent thing? :)
     
  2. HerronScott

    HerronScott Well-Known Member

    6,152
    679
    Jan 1, 2002
    Staunton, VA
    No. A few people here have talked about trying to use an older TiVo case but I don't think anyone has completed this project yet. :)

    Scott
     
  3. kkoh

    kkoh Member

    38
    14
    Mar 31, 2017
    oHIo
    Yeah I've searched around and haven't seen anything. I guess the knockouts on the back would make for a need of a crafty type which I am not.
     
  4. Anotherpyr

    Anotherpyr Active Member

    306
    57
    May 6, 2015
    I picked up a couple of series 2 for this but that is all. Biggest challenge is the location of the cable card on the bolt. I’m waiting on picking up a dead or used bolt cheap to use for laying everything out. Plus I wanted to look into replacing the heat sink with something better and wanted a test board for seeing how hard it is to remove the existing one.
     

Share This Page