Separate names with a comma.
I have been advised that zeroing the drive is probably best. The WD Diagnostic tool has a quick way to do this by writing zeros to the beginning...
i will give it a shot and let you know.
Is there an earlier version of the iso or other compiled version that I could test as a control.
I have installed VirtualBox on my Mac Mini and I successfully installed MFStools 3.2.
I can see all of the drives, however I still...
The dd copy on the 4TB drive successfully booted my tivo.
I made the copy on my mac mini.
I again tried to mfstool copy from the...
The copy is still running on dd.
I will let you know if it boots the bolt when it finishes.
Regarding HW, I have seen this in my laptop and...
I meant to ask on my last post, when this dd copy finishes, will this drive be done, such that I can put it in my Bolt?
I tried "mfstool copy -i /dev/sdX /dev/sdY" and got the same error on the copy as with "mfstool copy -ai /dev/sdX /dev/sdY"
Yes, all the same except drive designation.
OK I tried yet another USB 3.0 drive bay with the 4TB same error on copy.
Also, I zeroed out my 1.5TB drive and tried it and got the...
I have used both the iso (laptop) and the usb (mac mini) and had the same problem.
The "fdisk - l" command correctly identifies the...
I have 1TB Bolt drive as the source.
I can try a copy to 1.5T and let you know what happens.
Any thought on letting Tivo format...
OK, I just got a virgin out of the box 4TB Toshiba drive.
And all of the exact same errors.
Since I have changed everything else I begining...
Well it was a learning experience, but I was able to get MFSTools 3.2 running on my Mac Mini.
Bad news is the errors are the same for the...
I get same error except for the drive designation.
"copy target: Internal error opening partition /dev/sdc38654705664 for...
Both docks purportedly support 6TB drives.
Yes, I tried that and still the same response.
I am setting up the USB for the Mac Mini.
I'll report back what happens.
I believe I can use my Mac Mini, so I will try that.
FYI, I tried a different dock and same problem.
I gave it a shot and I got the same error as the earlier copy attempt.
copy target: Internal error opening partition...
I will give it a shot and let you know what happens.