Advertisements
Separate names with a comma.
The cablelabs cablecard spec requires boxes that do NOT have cablecards must read the cvct and tvct psip information on the cable input. So, if...
If you're not able to tune for Cable, no way it's the update to Rovi data that did it. The cablecard provides the tuning data, and it doesn't...
Other than getting out some frustration with this post, it may be more beneficial in the long run to provide some specifics of what's wrong, so...
No. Rerunning Guided Setup doesn't impact the CableCARD at all.
I'd look at this comment from TiVoMargret: http://www.tivocommunity.com/tivo-vb/showthread.php?p=10303348#post10303348 This message in the...
Before you copy/paste from someone else's post from DBSTALK.com, please make sure you understand what you're copying. This list is NOT "missing...
Other than allowing time to pass, Guided Setup isn't going to do anything to make the cablecards start working. Guided Setup just configures the...
The Auth line is specific to the channel you're tuned to, so that's why it's different at different times you check. I'd read through this...
Why bother with steps 1, 2, 4? Just remove the old cards & put in the new ones.
The VCT ID is the "Virtual Channel Table ID" This is the number that identifies the specific channel map your cable company is providing. In...
Or, I've read somewhere, maybe it has a worse (less sensitive) tuner, so it doesn't notice the errors, even though they're there.
The cablecard spec says that technically it's possible to apply copy protection to unencrypted channels, but it's not recommended. I know that...
Huh? This post makes no sense. A) If your Dad's tivo is marking unencrypted things as copy protected (and if he doesn't have cablecards,...
Huh? If you don't have a cablecard, there's no way for something to be marked with the copy flag.
The scan will allow you to watch the channel/schedule manual recording. But, scheduled recordings will "just work" once your tivo gets the updated...
As you noticed, scanning will find the relocated stations, but only tivo can update the guide data with the new frequencies. I just made a service...
Read the website more carefully. It does not recommend doing it during guided setup. The instructions for "Before the installer arrives" states:
What does a channel scan get you here? Tivo adds all the channels that the cablecard tells it about into the channel list, even if there isn't...
It only needs to be paired to receive copy protected channels (i.e. non-zero CCI). If none of the channels you want to receive are copy...
Sounds right to me. The picture in the Tivo settings screen will also confirm that :).
