Separate names with a comma.
Fixed in five days. Thanks!
A CW logo is needed for Spectrum channel 786, ZIP code 49685. Any help would be appreciated.
Did you reassign the input under settings? If not, reconnect the the s-video, go to settings/video/video hookup. It will take you through it.
Could it be that it is configured for S video input?
While looking at you Now Playing List, press the 2 button on your remote once. Did the folders return?
I have a Toshiba SD-H400 with software version 9.3.1 and it works well with the Zenith/Insignia converter.
The "-" input is the advance button. My remote code is 10090B. It might be a little faster than 10090A.
I would try again with the 931 priority site. My Toshiba 565 updated perfectly.
Choose the antenna only selection. You will then be prompted to choose which CECB you have.
I just received the 9.3.1 update. It works great with my Zenith DTT901.
You're right, a S3 would be good choice. However at the moment my old S2 is in my daughter's room hooked up to an old SD Sony and most of her...
I was thinking about the choice during setup. I'll use a splitter for the converter and the rf input.
Will there be a dtv conveter + antenna choice? I'll still have a low power analog station after the conversion.
I just received my DTVPal today and I find that works with Dishnetwork for the local into local channel lineup. All two digit channels are now...
Check this out.
You can record analog channels if you choose satellite with antenna and split the antenna input to the tivo and coverter. Lockout all the analog...
Has anybody run "repeat guided setup" to see if dtv converter boxes are supported?
I tried a friends TB100MW9 and couldn't find any code choice (Magnavox, Phillips) to control it. It also needs a decimal point input for direct...