TiVo Community Forum banner
  • TiVoCommunity.com Ambassador Program Now Open! >>> Click Here

Is there a trick to Bolt cablecard install?

1K views 21 replies 9 participants last post by  DVR_Dave 
#1 ·
Just got a Bolt Vox 1TB through the upgrade deal. I am trying to get the M-Card from my Premiere XL4 into the little slot on the bottom and just can't seem to get it to click in. I'm afraid I'm going to break something. The label is facing me and from everything I've read it's the correct way to do it, but it just won't pop in. Is there some trick or perhaps I'm doing something wrong?
 
#21 ·
The Vox Bolts are voice enabled, so in order to activate the CableCard slot, you need to use the voice commands to direct it to accept the CableCard. Say clearly "Cablecard port, open now!" to cause it to slide open and enter a receptive state. When it's not plugged in the microphone sensitivity is low so you may have to scream it loudly a few times before it works.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top