|
unknown boot block signature: xxxxxxxxx
My first time using copykern. I got two error messages when using the canned copykern commands built into the PTV large kernel disk. First ":no such file or directory" after the -k /cdrom/s1_kernels/kernel-3.0/vmlinux-3.0.px.gz command ran. Then "writing 1058304 bytes to /mnt/kernel.orig" ran. Then the error message "unknown boot block signature: 0xdb1dfac2" on a new line. Then final line indicates the kernel was updated.
I assume the first error message was no problem since that directory was not already on the hard drive, but is the second one important or not?
__________________
funtoupgrade
TiVo 240060 with 200GB Seagate
Humax DRT800 with 300GB Seagate
____________________________
Bought over 400 TiVos on eBay, most
without problems - subbed & unsubbed units
|
