Picked this Series 2 TDC240040 that gets stuck on Welcome. Powering up... the hard drive was replaced by the previous owner at some point, I replaced the ribbon cable and I can hear the drive spin up at power up.
I also tried putting my old maxtor drive from my TDC24004A however that exhibited the same result. I took another drive I had and used winmfs to restore a backup (240080) but I'm guessing it can't use that backup as it didn't work either.
I'm trying to get this machine working without laying out more money than I could have purchased a working unit for.
Perhaps someone might have the proper image for this unit that I could try?