I am going crazy here. Have two new Roamio Pro. I want to create a MOCA connection.
Pro number 1 is the one next to the router and Pro 2 will be in the living room far away from any ethernet connection.
Pro 1 is properly connected, coaxial and ethernet.
I select Network, Change network settings and Use this dvr to create a MOCA network. I select "yes, turn on MOCA" then I use the suggested settings. I select "get ip automatically (typical) and I get the message
"The DVR will begin using your new network settings".
When I select continue I see under "Network connections details"
Type: Ethernet connection
That is all i see. I tried this so many times. I replaced two XL elite and there was no problem with my MOCA connections. So the splitters and cables are not the problem.
I also remember that the type of connection it used to said when I bridge one of the elites was
Ethernet + Moca
Here I don't see that. Maybe is enable and the Roamios does not mention the + MOCA part anymore?
I used the other Roamio Pro with the same results. Called Tivo Tech support and we were on the phone for about two hours. No luck.
Was told to "clear and delete everything" but I am not sure i want to go that route. I am afraid it will un-pair my cable cards and will have another hard time pairing them again. Really hard time.
I will apreaciate any help regarding this matter. For those so you that have a Roamio Pro setup as a moca/bridge, can you please let me know if your pro mention ethernet + moca in the connection settings?
Thank you in advance for the help