allonon
03-21-2009, 01:04 PM
hi all,
some quick help if you don't mind.
I have an HR10-250 running 6.3f. Finally decided to upgrade it to 6.4a. Downloaded the slices, installed them, copied my hacks over. Now it's in a reboot loop.
Pulled the drive to re-copy the backport usb and nic drivers and managed to fubar the old 6.3f install in the process so now I can't go back and I still can't get 6.4a to load, still in the reboot loop
I have another HD which I just just zippered to 6.4a this morning and it's working just fine.
How can I copy the working install that is on the working 6.4a to my failed 6.4a install so I don't lose the recordings on it?
thanks
:confused:
some quick help if you don't mind.
I have an HR10-250 running 6.3f. Finally decided to upgrade it to 6.4a. Downloaded the slices, installed them, copied my hacks over. Now it's in a reboot loop.
Pulled the drive to re-copy the backport usb and nic drivers and managed to fubar the old 6.3f install in the process so now I can't go back and I still can't get 6.4a to load, still in the reboot loop
I have another HD which I just just zippered to 6.4a this morning and it's working just fine.
How can I copy the working install that is on the working 6.4a to my failed 6.4a install so I don't lose the recordings on it?
thanks
:confused: