ARC
06-12-2007, 01:02 PM
I pulled my 750 gig Seagate from the HR10-250 and booted up on the CD I created with the zipper_isomaker.bat.
The pc boots fine and loads the os without any apparent errors or problems. The CD is on secondary master, and the TiVo drive is secondary slave (no jumper).
Once I get to a bash prompt, and
after mounting the cdrom with
mount /dev/hdc /cdrom and running the zipper script by issuing
cd /cdrom
zipper
Zipper performs exactly the same as before - it runs, but with an error displayed. It does not crash nor abort after the error. Does Zipper write a log anywhere so I can figure out what the copy error is dying on?
Zipper shows this:
copying busybox
copying author file
copying hacks to tivo drive
cp: read error: Input/output error
copying hacked kernel to tivo device
vmlinux.px.gz 40.4% - - replaced with vmlinux.px
1+1 records in
1+1 records out
kernel copied successfully
and it never shows any other errors as it proceeds through the zipper process. Once I down the box and move the disk back to the HR10-250 it refuses to run sh tweak.sh , never shows any errors or progress, just blinking cursor.
The pc boots fine and loads the os without any apparent errors or problems. The CD is on secondary master, and the TiVo drive is secondary slave (no jumper).
Once I get to a bash prompt, and
after mounting the cdrom with
mount /dev/hdc /cdrom and running the zipper script by issuing
cd /cdrom
zipper
Zipper performs exactly the same as before - it runs, but with an error displayed. It does not crash nor abort after the error. Does Zipper write a log anywhere so I can figure out what the copy error is dying on?
Zipper shows this:
copying busybox
copying author file
copying hacks to tivo drive
cp: read error: Input/output error
copying hacked kernel to tivo device
vmlinux.px.gz 40.4% - - replaced with vmlinux.px
1+1 records in
1+1 records out
kernel copied successfully
and it never shows any other errors as it proceeds through the zipper process. Once I down the box and move the disk back to the HR10-250 it refuses to run sh tweak.sh , never shows any errors or progress, just blinking cursor.