clctx
12-12-2006, 12:30 PM
I need some help.
Series I - Phillips DSR6000R01
Upgraded HD to Maxtor DiamondMax 160 ATA about 7 months ago using InstantCake.
Added LBA48 kernal using PTV's 4.04 LBA48 CD after system updated software.
All worked well until sometime in the last week when the system went into reboot loop - reaches powering up screen then starts again.
Took drive out and scanned it with drive tools doing a full surface scan and the drive has no problems.
Any suggestions on how I might get the system to run. I would like to keep all the recordings if at all possible.
Thanks for the help.
Chuck
Series I - Phillips DSR6000R01
Upgraded HD to Maxtor DiamondMax 160 ATA about 7 months ago using InstantCake.
Added LBA48 kernal using PTV's 4.04 LBA48 CD after system updated software.
All worked well until sometime in the last week when the system went into reboot loop - reaches powering up screen then starts again.
Took drive out and scanned it with drive tools doing a full surface scan and the drive has no problems.
Any suggestions on how I might get the system to run. I would like to keep all the recordings if at all possible.
Thanks for the help.
Chuck